Control-company 4376 SNAP-IN THERMOMETER MODULE WITH PROBE Bedienungsanleitung PDF herunterladen

Traceable

SPECIFICATIONS

Range: –58 to 572 °F

–50 to 300 °C

Resolution: 0.1° from -20° to 200° 1° otherwise

OPERATION

1. Press the ON/OFF button to turn the unit on. Press the °F/°C button to switch between Fahrenheit and Celsius.

2. Insert the probe into the material to be measured and read the display.

3. Press the ON/OFF button to turn the unit off. To conserve battery life, always turn the unit off when not in use.

MAX/MIN MEMORY

1. To view the minimum temperature reached since activating the unit, press the MAX/MIN button. “MIN” appears on the display to indicate the

minimum temperature recorded.

2. Press the MAX/MIN button a second time, within 3 seconds, to view the maximum temperature reached since activating the unit. “MAX”

appears on the display to indicate the maximum temperature recorded.

Note: Three seconds after pressing the MAX/MIN button, the unit automatically returns to the current temperature reading. (“MIN” and “MAX” are no

longer displayed.)

3. Turn the unit off to reset the minimum and maximum memories.

ALL OPERATIONAL DIFFICULTIES

If this thermometer does not function properly for any reason, replace the battery with a new high quality battery (see the “Battery Replacement”

section). Low battery power can occasionally cause any number of “apparent” operational difficulties. Replacing the battery with a new fresh battery

will solve most difficulties.

BATTERY REPLACEMENT

Erratic readings, a faint display, no display or appearing on the display are all indications that the battery must be replaced. Using a coin, turn the

battery cover on back of the unit in the direction of the “open” arrow. Remove the exhausted battery and replace with a new 1.5 volt silver-oxide 357

size battery. Make certain positive (+) side is visible. Replace battery cover.

WARRANTY, SERVICE, OR RECALIBRATION

For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714 Fax 281-482-9448

E-mail [email protected]

www.control3.com

Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025

accredited as a Calibration Laboratory by A2LA.

TRACEABLE

SNAP-IN THERMOMETER MODULE WITH PROBE INSTRUCTIONS

CONTROL COMPANY 1

Inhaltsverzeichnis

Seite 1 - CONTROL COMPANY

Kommentare zu diesen Handbüchern

Keine Kommentare

Control-company 4376 SNAP-IN THERMOMETER MODULE WITH PROBE Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Thermometer Control-company 4376 SNAP-IN THERMOMETER MODULE WITH PROBE herunter. Control Company 4376 SNAP-IN THERMOMETER MODULE WITH PROBE User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Thermometer Control-company 4376 SNAP-IN THERMOMETER MODULE WITH PROBE